The compact pedestrian flap barrier is designed to control pedetrians entering or existing restricted areas usually under surveillance, and in particular low security areas. Passage frequency is 30 people per minute. Commonly used to control both directions, the barrier may operate with card access, token acceptor or other remote device which produces a clean contact closure for authorized passage. The fabricated housing is folded from either 2mm thick electro-galvanized steel sheet or 1.5mm thick stainless steel of different grades. An epoxy powder coat provides corrosion protection and an attractive finish. The modules are then assembled together by bolts and nuts to form the housing. The housing has two removable end modules allowing access to the electrical terminations and electronic control. The housing is attached to the concrete floor using dyna-bolts or similar
Key Features
- Drive system incorporates a 100% Duty cycle 60V AC 50Hz torque motor
- No limit switches or slip clutches
- When in close position, continuous 60V AC will prevent flaps from being forced open
- In event of power failure, flaps open automatically by return spring and can also remained
closed upon request
- Minimum noise with cushioning rubber buffer and dynamic braking
- End modules with reserved space for card reader, token container and optional LED signage
